Installation and maintenance instructions
In order to ensure the overall effect of the exhibition hall decoration, please try to consider the exhibition hall layout as a whole during the exhibition hall design stage and before construction, including the requirements and precautions for the location of the exhibition racks and the installation site of the exhibition racks:
● Floor-standing installation requires that the ground be level and flat, and the entire ground must be hard and solid;
● Nail wall installation requires a solid wall or a wall that has been reinforced to bear sufficient force, and the entire wall must be flat and perpendicular to the horizontal ground;
● Top installation requires that the top surface be stable and capable of bearing capacity, the entire top surface must be flat and parallel to the horizontal ground, and the top-to-bottom inner height error must be within 5mm;
Before installation, please read the installation manual or installation video, install the display rack according to the corresponding steps and requirements, and please pay attention to the following installation, debugging precautions and product maintenance instructions:
● Display racks are similar to furniture products. It is recommended to install the display racks after the exhibition hall is decorated and cleaned. Products containing board products such as MDF must be waterproof and moisture-proof, and be particularly careful not to be soaked in standing water or excessively damp;
● Please use the installation tools correctly, and you must use scientific tools such as a level to control installation errors and debug and straighten the display racks;
● Those installed on the wall must be firmly installed on the wall, those installed on the ceiling must be firmly installed on the top, and those installed on the floor must stand firmly on the ground;
● For structures with a main frame that stands independently on the ground, check the horizontality and verticality of the main frame. After alignment and debugging, tighten the screws of each part. Use blasting and nailing to the ground or wall for reinforcement according to actual needs, especially if the depth is narrow. The shallow and high main frame must be reinforced by nailing and pulling the wall;
● Pulling plates are installed up and down with wheels that move on tracks. The plane of the pulling plate should be parallel to the installed upper and lower rails and perpendicular to the ground. Check the flatness and verticality of the pulling plate, judge the parallelism and parallel distance of the upper and lower rails, and make appropriate adjustments. ;
● Wheels running in grooved rails require detection and adjustment to ensure that the wheels are sufficiently in the grooves. Especially for grooved rails installed on the top of extremely long spaces, it is necessary to check that the wheels are sufficiently in the grooves and adjust them. Note that the entire length must be All travel ranges must be tested;
● The product fixation method is hemming and edge clamping/hook/pull hook/hook, etc. All must check that the clamp/pull/hook position is sufficient to fix the product;
● If it contains lamps, electric appliances and other electrical equipment, be sure to use electricity safely, standardize wiring, standardize the operation and use of electrical equipment, and strictly prohibit illegal wiring and exposure of wires;
● The products placed on the display rack must be within the load-bearing range of the display rack. The products have a certain weight and movement inertia. Please operate them reasonably and gently. Violent operations including violent pushing, pulling, and impacting, etc. that pose safety hazards are prohibited.
● Please arrange for installation personnel with relevant and rich experience to carry out the installation, which will make the entire installation process smoother. Please complete other matters that are not covered based on scientific and reasonable experience.
● Exhibition rack maintenance: Regularly clean and maintain the exhibition rack. It is recommended to use maintenance polish to clean the display rack, and frequently check whether the bolts at all connectors are loose or abnormal, and repair them in time;
● Exhibition stand warranty: The main product and accessories are guaranteed for one year, and long-term technical support is provided;
● We will optimize and update the product according to actual needs. Changes in size and structural parameters will not be subject to further notice. In particular, customized products are subject to actual communication.
The installation instructions, screws and other accessories required for the display rack will be in the packaging box. Usually, most customers can successfully complete the installation and debugging of all products. If you encounter any unclear situations during the installation process, please contact us.